Step By Step Guide On Making A CD Case For D+T Resistant Materials Essay Example for Free

Step By Step Guide On Making A CD Case For D+T Resistant Materials Essay 1. Find right equipment; ruler, chisel, sand paper, glue, pine and ply 2. Measure the right lengths of wood and then cut into 4 separate parts 250mm for the lengths and 170mm for the widths Equipment needed; Ruler, saw, pencil 3. Create a rectangle for the main frame-using lap joints (250mm high and 170mm in width, sand if needed), 4. Equipment needed; chisel, hammer, glue and pencil 5. Create long thin pine about 95mm long and 7mm high (so they look a bit like sticks) make about 12 pieces (6 ether side) to make the support for the CDs Equipment needed; pencil, saw, ruler 6. Glue the pine sticks to the inside of the frame making sure that nothing sticks out using sand paper, and also making sure that it only goes about 3/4 of the way down to leave space for the storage area. Equipment needed; glue, sand paper 7. Before sticking on the plywood make sure the CDs fit in between the frame nicely Equipment needed; CD 8. Making sure that nothing is sticking out and that the measurements are all correct glue the plywood on to the back of the pine frame. Equipment needed; ruler, glue 9. Sand down any sticking out bits to make it look presentable. Equipment needed; sand paper 10. Sand the corners to make it aesthetically pleasing as possible. Equipment needed; sand paper 11. Then for a finishing touch add water based vanish. Equipment needed; vanish